Вроде я разобрался с заданием кривой В(Н), зависящей от температуры.
Написано в описании про это – хрен поймешь.
Что за k=10 на базовой температуре я так и не понял. Какую температуру считает начальной, тоже большой вопрос.
Скорее всего, что задано в тепловой задаче, как начальная. Хотя не факт.
Я задавал k=1 при начальной температуре, затем снижал. Для получения магнитной проницаемости близкой 1, надо сделать k достаточно маленьким. Например, 0.00001. Ноль считать отказывается.
Выдержка из хелпа.
Magnetizing Properties [B-H Curve (Temperature dependent)]
This property is used for a coupled magnetic field and thermal analysis.
This is a soft magnetic material which changes by temperature and specifies a nonlinear characteristic for a magnetic field. Create a base temperature for B-H curve (magnetic field - magnetic flux density curve) and a table for temperature and magnetic susceptibility. A temperature is determined by coupling with a thermal analysis.
The base temperature is k=10 that is based on the table for the temperature and magnetic susceptibility. [k=1.0] needs to be specified in the table for the temperature and magnetic susceptibility.
The following process is used when calculating the temperature - magnetic susceptibility from a B-H curve of each temperature. The last point of each B-H curve needs to reach the saturation area of a region.
1. The magnetization M(T) is calculated from the last point of the B-H curve for temperature T.
2. The magnetic susceptibility [k=M(T) / M(T0)] for each temperature is calculated by using magnetization M(T0) from the base temperature T0.
• The temperature distribution condition needs to be set when using magnetic material with temperature-dependent magnetic property for JMAG-Designer.
Как обычно, пример. Запускать через шедулер. Ставить разные сетки.
teplo3.jproj скачать с Файлы@Mail.Ru